The Elegoo Saturn 4K Monochrome LCD/MSLA 3D-printer is an open printer with a 405 nm light source, compatible with 3rd party resins. Some resins have been optimized. Most other resins could also work on this printer, however, not all pre-settings are available. Contact us if you need support or have any questions.
Resin | Layer thickness | Exposure time (seconds) | Base layer count | Base layer exposure | Lift Height | Lift speed / retract speed (mm/min) | Light off-delay / bottom (seconds) |
Flexible-X | 100 µm | 26 | 2 | 75 | 10 | 45 / 90 | 2,0 / 3,0 |
50 µm | |||||||
Deep Blue | 100 µm | ||||||
50 µm | |||||||
Stone Coal Black | 100 µm | ||||||
50 µm | |||||||
Premium White | 100 µm | ||||||
50 µm | |||||||
Premium Black | 100 µm | ||||||
50 µm | |||||||
Premium Model | 100 µm | ||||||
50 µm | |||||||
Premium Tough | 100 µm | ||||||
50 µm | |||||||
Wax Castable | 100 µm | ||||||
50 µm | |||||||
Premium Flex | 100 µm | ||||||
50 µm | |||||||
Clear Impact | 100 µm | ||||||
50 µm | |||||||
Strong-X | 100 µm | ||||||
50 µm | |||||||
Tough-X | 100 µm | ||||||
50 µm | |||||||
Hazard Glow | 100 µm | ||||||
Composite-X | 100 µm | ||||||
50 µm |
*all profiles used 6 transition layers, except otherwise noted.
Support settings for Flexible-X, Tough-X and Premium Flex resin
Supporting flexible and some tough materials, would require extra attention. During printing these materials are very soft and the supports, support tips and intersection with the model should be big enough to support the models during printing. These settings have been used with succes for Flexible-X. Tough-X and Premium Flex would require similar support settings:
Support
Do you need any help with 3D printing our SLA, DLP or LCD resins? We can help you! Just look for the question you have below. If you can’t find it, let us know by contacting us!